Omron F3SG-R Series, User Manual

Page: 87 / 128

67
F3SG-4RA-25-02TS
User’s Manual
Chapter
4
M
ount
in
g
Wiring/Installation
E
7.
Power the F3SG-R on to perform beam alignment.
Move the emitter and receiver from side to side (Fig. 8) to align them to a center position where the
Stable-state indicator (STB, green) of the receiver is illuminated while checking the state of the top and
bottom beams with the Top-beam-state indicator (TOP, blue) and Bottom-beam-state indicator (BTM,
blue) of the receiver. (Fig. 9)
- The angle adjustment range is ±22.5° when using the Top/Bottom Brackets only.
- The angle adjustment range is ±15° when using the Top/Bottom Brackets and Intermediate Bracket together.
- It is recommended to use the Light Level Monitoring with the Configuration Tool for beam alignment. Refer to
Safety
Light Curtain Configuration Tool for Model F3SG (SD Manager 2) User’s Manual for more information.
8.
Securely tighten the Alignment Screws of the Top/Bottom Bracket and Intermediate Bracket to fix the
bracket to the F3SG-R housing. The recommended torque to tighten the Alignment Screws is 3.0 N•m.
(Fig. 10)
Tightening screws with a torque that considerably exceeds the recommended torque may cause failure.
Fig. 8 Fig. 9
<Emitter>
EMITTER
<Receiver>
RECEIVER
TOP(Blue)
STB(Green)
BTM(Blue)
Fig. 10
Alignment Screws
(Top/Bottom
Bracket)
<Backside mounting>
Alignment Screws
(Top/Bottom Bracket)
Alignment Screws
(Top/Bottom
Bracket)
<Side mounting>
Alignment Screws
(Intermediate
Bracket) Alignment Screws
(Intermediate
Bracket)
Alignment Screws
(Top/Bottom Bracket)
Securely
tighten these Securely
tighten these
Securely
tighten these
Securely
tighten these Securely
tighten these
Securely
tighten these