Omron F3SG-R Series, User Manual

Page: 39 / 128

19
F3SG-4RA-25-02TS
User’s Manual
Chapter
2
External Test
System Operation and Functions
E
2-5. External Test
2-5-1. Overview
This function stops the emission using an external signal. It can be used to verify that a safety system
should properly stop (safety output turns OFF) when F3SG-R is blocked.
To stop the emission, apply the following voltage to the emitter's TEST input line according to the End
Cap settings of the emitter.
 Basic wiring diagram
 Timing chart
2-5-2. Factory Default Setting
The factory default setting is 24 V Active with the black End Cap attached to the F3SG-R.
2-5-3. Setting
The user can select the setting from 24 V Active or 0 V Active by switching the End Cap.
Refer to Chapter 3 Setting with Rotary Switch and End Cap for more information on setting this function by
the Rotary Switch.
End Cap settings 24 V Active 0 V Active
Input voltage 9 V to Vs 0 to 3 V
End Cap Black White
㻱㼙㼕㼠㼠㼑㼞 㻱㼙㼕㼠㼠㼑㼞
24 V Active 0 V Active
+24 VDC
Power Supply
S1: Test Switch (Connect the line to
0 V if this switch is not required)
S1: Test Switch (Connect the line to
24 V if this switch is not required)
0 VDC
+24 VDC
Power Supply
0 VDC
+24 VDC: Brown
TEST: Black 0 VDC: Blue
+24 VDC: Brown
TEST:
Black
0 VDC: Blue
S1
S1
F39-JD A-L F39-JD A-L
TEST
OFF
OSSD
ON
OFF
ON
Toff: Response time ON to OFF
Toff × 4 or less
Toff × 8 + 100 ms or less