Omron Enterprise Manager 2100, User Manual

Page: 61 / 96

Chapter 6: Operation
This chapter describes how to operate the Enterprise Manager appliance. It includes the fol-
lowing topics.
6.1 Turn Enterprise Manager 2100 Power ON and OFF
61
6.2 Generate a Workspace Map for Your Fleet
64
6.3 Managing Queuing
64
6.4 Update the ARAMCentral Software
71
6.5 Enterprise Manager 2100 Autosync Operation
71
6.6 Remove and Replace Enterprise Manager 2100 Appliances from Autosync
72
6.7 What to do if an EM2100 Primary Appliance Fails
74
6.8 What to do if an EM1100 Autosync Appliance Fails
74
6.9 Troubleshooting
76
Be aware that before you proceed, you must complete the steps in Installation on page 21 and
Configuration on page 45.
6.1 Turn Enterprise Manager 2100 Power ON and OFF
Use the front momentary power switch to control AC power. The rear switch should remain
on unless you are uninstalling the appliance.
Safe Power On
Use the following power on procedure only if you are sure that the environment was safely
shut down and is ready to restart. Otherwise, see: Power On After a Hard Shutdown.
1. Press and hold the front Power switch to power-on the Enterprise Manager appliance.
The power LED illuminates immediately.
2. Observe the boot message sequence in the display panel.
3. If there are no boot errors, the boot sequence can take up to two minutes, typically less.
Soft Shutdown and Power Off
The following procedure initiates a soft shutdown (preferred), where the operating system runs
through a graceful shutdown procedure. For emergency shut down, see Hard Shutdown and
Power Off.
1. Press and release the front power switch to start the shutdown sequence for the Enter-
prise Manager appliance.
2. Wait for the Appliance to beep three times.
3. Observe the shutdown messages on the control panel.
14413-200 Rev. A Enterprise Manager 2100 User’s Guide 61