Omron Enterprise Manager 2100, User Manual

Page: 46 / 96

46 Enterprise Manager 2100 User’s Guide 14413-200 Rev. A
5.1 Enterprise Manager 2100 Configuration Overview
Port Description and Use IP Address
SYNC ETH3
(Autosync
Port)
Not used in this release. None
Contact your System Administrator for assistance configuring the Enterprise Manager appli-
ance for your network. See also: Site Networking Requirements on page 23.
Configuration Tasks Overview
To connect to and configure the Enterprise Manager appliance, you must do the following
tasks, which are described in detail later in this guide:
l
Set an IP address on your PC's Ethernet adapter.
l
Connect your PC to the Enterprise Manager appliance.
l
Use a browser to access the SetNetGo interface.
l
Configure the network settings for the appliance Management Ethernet port.
l
Configure the network settings for the FLEET ETH2 Ethernet port.
l
Define the login information.
l
Configure each AIV to connect to the Enterprise Manager 2100.
l
Customize each AIV, if desired.
If you also install a Secondary appliance and configure Autosync, you must also:
l
Install the same SetNetGo and ARAMCentral software version on the Secondary as is
on the Primary appliance.
l
Configure a unique IP address for the Management port.
l
Connect the Management port to the LAN.
l
Connect the FLEET ETH2 port to the LAN.
l
Enter the Secondary Management IP address on the Primary appliance.
l
Generate and download a key from the Primary appliance.
l
Set the Secondary appliance Autosync role to Secondary.
l
Upload the key to the Secondary appliance.
l
Verify that the status of both appliances is active.
l
Create a direct network connection between the Primary and Secondary appliances.