3 Basic Application Procedures
3 - 4
E3NW-CCL CC-Link Digital Sensor Communications Unit User’s Manual (E431)
3-2
Setting and Wiring Hardware
This section describes how to set up and wire the CC-Link master, Communications Units, and power
supplies.
Mount the CC-Link master at the specified location and set the unit number and other settings. For
details, refer to the manual for your CC-Link master.
Mount each Communications Unit and Distributed Sensor Unit in the designated locations, then set the
station numbers and other settings. For details, refer to the following items.
Installation
Hardware Settings
on page 5-6
Set the baud rate, operating mode, and station number.
Connect communications cables to the CC-Link master, Communications Units, and Distributed Sensor
Units. Refer to
4-2 Wiring the CC-Link Network
for wiring procedures.
Connect the Unit power supply to the CC-Link master, slaves, and the Distributed Sensor Units.
Connect the I/O power supply unit to each slave as required.
For connection method details, refer to
4-3 Connecting the Unit Power Supply
or refer to the wiring
diagrams for each slave.
Connect the Sensor Amplifiers to the Sensors. For connection methods, refer to your Sensor Amplifier
manual.
Reference
When using the Distributed Sensor Unit, refer to
A-4 Using the Distributed Sensor Unit
on page
A-22 as well.
3-2-1
Mounting and Setting Up the CC-Link Master
3-2-2
Mounting and Setting Communications Units
3-2-3
Wiring the Communications Cables
3-2-4
Connecting the Power Supplies
3-2-5
Connecting the Sensors
Summary of Contents for E3NW-CCL
Page 1: ...E3NW CCL CC Link Digital Sensor Communications Unit User s Manual Cat No E431 E1 08 ...
Page 114: ...A Appendices A 34 E3NW CCL CC Link Digital Sensor Communications Unit User s Manual E431 ...
Page 116: ...B B 2 E3NW CCL CC Link Digital Sensor Communications Unit User s Manual E431 ...
Page 117: ......
