4-3
Manually Setting Data Links
4-3-2
Creating Data Link Tables
4-3-2 Creating
Data Link Tables
Create a data link table for each node registered in the CX-Server file that is read.
Make the settings for (1) to (8) below.
Node 2
(receive)
(3)
Area setting
(area/start
address)
(4) Send size
(2) Node 1
PLC type
Node 1
(send)
Node 3
(receive)
(7) Receive
sizes from
remote nodes
(5) Node refresh sequence:
2, 1, 3
1, 2, 3
2, 1, 3
(6)
Status area
Node 3
(receive)
Node 3
(send)
Node 2
(send)
Node 1
(receive)
Node 1
(receive)
Node 2
(receive)
Data link
status
Data link
status
Data link
status
Node 2
PLC
Node 3
PLC
(8) Offsets
(1) Participating data link nodes
To create a data link table, make the following settings in order.
1. Datalink Wizard Settings
(1) Set participating data link nodes.
(2) Set the PLC type.
(3) Set the areas.
(6 ) S e t th e status a re a.
(5) Set the refresh node sequence.
(4) Set the send size.
4-9
Summary of Contents for CX-INTEGRATOR - V1.1
