6
System Configuration
Section 1-2
1-2-3
Mounting Units
CS-series PLCs
Use the following procedure to mount an ID Sensor Unit to the Backplane.
1,2,3...
1.
Lock the top of the ID Sensor Unit into the slot on the Backplane and rotate
the Unit downwards as shown in the following diagram.
2.
While making sure to align the Unit properly with the connectors, tighten
the mounting screws securely to a tightening torque of 0.4 N·m.
3.
To remove the Unit, first loosen the mounting screws using a Phillips
screwdriver.
Note
Leave enough space below each Rack, as shown in the following diagram, for
mounting and removing the Units.
Hook
Backplane
Mounting screw
20 mm min.
20 mm min.
Backplane
Phillips screwdriver
Summary of Contents for CJ - 12-2004
