Olympia Omega 1640, User Manual

Page: 55 / 327

2-13
Pr
ecau
tio
n
Chapter 2
22 23 24 26 25
27
28
29
30
No. Part name Description
22 [Fax] key Press to enter Fax mode. The indicator on the key lights up in green to
indicate that the machine is in Fax mode. (Available only when fax kit
FAX-4000 is installed)
23 [Scan] key/indicator Press to enter Scan mode. The indicator lights up in green to indicate that
the machine is in Scan mode. (Available only when network interface
card NC-4000 or image controller PCL-4000 are installed)
24 [Copy] key/indicator Press to enter Copy mode. The indicator lights up in green to indicate that
the machine is in Copy mode.
25 [123/ABC] key Press to switch between number input mode and letter input mode.
(Available only when fax kit FAX-4000, network interface card NC-
4000, or image controller PCL-4000 is installed.)
26 [Reset] key • Press to clear all settings (except programmed settings) entered from
the control panel.
• Press to delete the job being specified.
27 [Interrupt] key/indica-
tor Press to enter Interrupt mode. The indicator lights up in green to indicate
that the machine is in Interrupt mode.
Press the key again to cancel Interrupt mode and return to the mode be-
fore Interrupt mode was entered. (See p. 4-62.)
If this key is pressed while a computer document is being printed, print-
ing stops so that the interrupting copy job can be performed. Press this
key again to continue printing the computer document.
28 [Clear/Stop] key • Press to clear the entered number and letters.
• Press to stop a continuous copy operation.
• Press to stop the print job from the computer.
29 [Start] key/indicator • Press to start a copy operation.
• If this key is pressed while this machine is warming up, the next copy
job is queued. (See p. 2-19.)
• The key lights up in green to indicate that copy jobs can be queued,
and the key lights up in orange to indicate that the machine is not ready
to begin copy operations.
30 Keypad • Use to type in the number of copies to be produced.
• Use to enter the setting values.