Olivetti D-COPIA 6200, Advanced Operation Manual

Page: 196 / 211

Appendix
Appendix-7
Postcards
Before loading postcards into the MP tray, fan them
and align the edges. If the postcard paper is curled,
straighten it before loading. Copying onto curled
postcards may cause jams.
Do not use perforated return postcards.
Some postcards may still have rough edges on the
back side caused by a paper cutter. Remove any such
rough edges by placing the postcards on a flat surface
and rubbing the edges gently a few times with a ruler.
Envelopes
Use the MP tray for envelopes.
Due to the structure of envelopes, copying evenly over the entire surface may not be possible in
some cases. Thin envelopes in particular may be wrinkled by the copier in some cases as they pass
through it. Before purchasing envelopes in volume, try testing a sample to ensure the copy quality.
Storing envelopes for a long period may cause them to become wrinkled. Thus, keep the package
sealed until you are ready to use them.
Keep the following points in mind.
Do not use envelopes with exposed adhesive. In addition, do not use the type of envelope in which
the adhesive is exposed after the top layer is peeled off. Serious damage may be caused if the
paper covering the adhesive comes off in the copier.
Do not use envelopes with certain special features. For example, do not use envelopes with a
grommet for winding a string to close the flap or envelopes with an open or film-covered window.
If paper jams occur, load fewer envelopes at once.
To prevent paper jams when copying onto multiple envelopes, do not allow more than ten envelopes
to remain in the output tray at once.
Thick Paper
Before loading thick paper in the MP tray, fan it and align the edges. Some thick paper may still have
rough edges caused by a paper cutter on the back side. Remove any such rough edges just as with
Postcards by placing the paper on a flat surface and rubbing the edges gently a few times with a
ruler. Copying onto paper with rough edges may cause jams.
NOTE: If the paper is not supplied correctly even after
it is smoothed, load the paper in the MP tray with the
leading edge raised a few millimeters as shown in the
figure.
Rough
edge
Rough
edge