ODA EX 100-12, User Manual

Page: 89 / 94

7-6. Interface Commands Error
This chapter is for PC interface communicaton error.
-120, "Suffix too long"
A suffix for a numeric parameter contained too long characters. Maximum memory buffer
that you are able to send is 50 byte at only once.
-121, "Invalid data"
An invalid character was found in the command.
ex) volt 10V Don't need character 'V"
You must revise to "volt 10".
-122, "Syntax error"
Invalid syntax was found in the command string. You may have inserted a blank space
ex)volt You skipped numeric value
You must revise to "volt 10".
-123, "Invalid suffix"
A suffix was incorrectly specified for a numeric parameter. You may have misspelled the suffix.
You added "*" after command.
You must revise to "volt 10".
-124, "Undefined header"
A command was received that is not valid for this power supply. You may have misspelled the command
or it may not be a valid command. If you are using the short form of the command,
The power supply just receive "Volt" or "Voltage"
You must revise to "volt 10".
-220,"No execution"
The power supply does not accept to execute.
ex)Volt 20 Set the voltage to 20V.
ㄴ
Volt:OVP 15 The error occurred when you set the OVP level lower
than setting voltage value.
-221, "Setting conflict"
Indicates that a legal program data element was parsed but could not be executed due to
the current device state.
ex)POL N
This is polarity change command, but could not be executed in current device.
-222, "Out of data"
A numeric parameter value is outside the valid range for the command.
Voltage setting value is too much big.
You must revise to "volt 10".
-223, "Incorret error"
It appears when you send new query command again without receiving former query
command execution from buffer.
ex)*idn? You sent query command to the power supply and
volt? immediately send again another new command.
- 90 -
ex)volt 10*
ex)volta 10
ex)volt 1000