Chapter 1 : Safety Instructions
9
AP-75037, Rev. 1.1, 24/04/2006
¾
Be sure to use the specified voltage (AC 100 V to 120V, or AC 220V to 240V). Otherwise,
electrical shock or fire may occur.
¾
Use electricity directly from a power outlet (AC 100 V to 120V, or AC 220V to 240V). Do not put
many loads on one electrical output. Otherwise, heat may be generated and cause fire.
¾
Be sure to use an outlet with an earth terminal and use the terminal correctly. Otherwise,
electrical shock or fire may occur.
¾
Follow the instructions below when handling the power cable.
o
Do not modify the cable.
o
Do not put heavy objects on the cable.
o
Do not bend, twist or pull the cable.
o
Do not wire the cable near equipment that generates heat.
¾
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
o
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it can go.
¾
When handling the foot switch, be aware of the following:
o
Do not place anything heavy on the foot switch.
o
Do not bend the cable of the foot switch with force and do not pull.
o
Do not place the foot switch near thermal devices.
¾
When handling ink cassettes, be careful that ink does not get in your eyes or on your skin.
However, if this happens, flush immediately with water and wash skin with soap. Otherwise, your
eyes may become slightly congested or inflamed. If you feel discomfort, consult a doctor
immediately.
¾
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
¾
Be careful not to pinch your fingers when opening and closing the cover of the ink compartment.
¾
Be careful not to pinch your fingers when opening and closing the front cover.
¾
Follow the instructions below when connecting the network interface cable. Otherwise, electrical
shock or fire may occur.
o
Do not touch the connector.
o
Do not connect the network cable connector that has not the same specifications to the
interface board.
¾
When cutting the roll media, be careful of the following. Incorrect handling can result in injury to
the hands and fingers from the razor blade.
o
When holding the media, do not place fingers over the media cut groove.
o
Move the razor blade slowly along the media cutting groove.
¾
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or
paint peeling from the casing.
¾
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
¾
Be careful not to touch the heaters during or after operation. Doing so may result in burns.
¾
Only use Eco Solvent Ink and appropriate cleaning liquid.
¾
Never open the covers fixed with screws, except the left cover. Doing so may result in electrical
shock or a malfunctioning of the printer.
¾
Do not touch the cutter blade. Doing so may result in bodily injury.
¾
Do not cut hard objects or drop the cutter. Doing so may damage or chip the cutter blade.
¾
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction of the product.
¾
Do not touch the cleaning wiper or the head cap unit with bear hands. Use a dust free cloth and
gloves to clean.
¾
Do not tilt the printer, stand it against a wall or turn it upside down. Doing so may cause ink to
leak inside the printer. Movement after transport is also not covered by the warranty.
¾
When installing options, do not touch the elements on the circuit board. The elements on the
boards can be very hot and can cause burns.
