Chapter 4 : Preparing for a job
58
AP-75037, Rev. 1.1, 24/04/2006
Step 4 :
Lock one roll unit to the roll unit bar
Step 5 :
Place one side of the roll over the flange of the locked unit.
Step 6 :
Slide the flange of the other roll unit into the roll and lock the unit by using the its handle.
Step 7 :
You can now de-lock both sides to do adjustment of the position of the roll. The middle of the roll
has to correspond to the middle of the printing space. After adjustment, lock both roll units again.
End of the installing the media procedure
Note :
•
We recommend to wear cotton gloves to avoid fingerprints on the inkjet media.
4.6.3 Loading the media into the printer
This procedure contains 2 parts (Part 1 and Part2)
P
ART
1
:
I
NSTALLING AN EMPTY CORE AND LOADING THE MEDIA THROUGH THE REAR TENSIONING
SYSTEM
(P
ROCEDURE
-
7
STEPS
)
Step 1 :
Make sure the printer and UW/W 100 are ON.
Step 2 :
Press the [F4] key to raise the pressure rollers.
Step 3 :
Open the front cover.
Step 4 :
Install an empty core between the motorized roll unit and roll unit of the winder unit on front of the
printer.
•
Make sure the core is longer then the media width.
Note :
•
Make sure the core is longer then the media width.
Step 5 :
Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.
Step 6 :
Use the foot-switch to release some media on the rear.
Next step on next page
