Chapter 5 : Handling the printer
112
AP-75037, Rev. 1.1, 24/04/2006
5.4.3.18 Halftone menu
When creating prints of MH-GL/GL2 (vector) data and RTL-PASS (raster) data that has not been converted
into binary, to set the screening method.
* Halftone. *
F1
→
Speed Quality
←
F2
F3
→
Thin
Current parameter
→
- Speed -
(1/1)
Setup items
Parameters
Description
<Speed>
To use the error diffusion matrix to perform rapid
screening.
Quality
Screening is performed at high quality according to
the method of minimal average error.
Thin
When printing data created for a competitor's printer,
make this setting if the Speed" setting could result in
dark prints.
Halftone
-
To shift to the previous menu.
Refer to
Command setup menu
5.4.3.19 Layout setup menu
Makes various settings on layout function.
Notes :
•
The layout function automatically determines the size of printing data sent from the
computer, and then determines the amount of roll media required without wasting
media.
•
If sheet media has been loaded, the layout function is disabled.
* Layout. *
F1
→
Direct. Joint
←
F2
F3
→
CtPos.
(1/1)
Setup items
Parameters
Description
Direct
To set the layout method for printing data.
Refer to ‘Layout method menu’
Joint
Makes settings for stitching print.
Refer to ‘Joint printing menu’
CtPos
To set the media cutting position after printing has
been completed.
Refer to ‘Cutting position Menu’
Layout
-
[CANCEL] key: To shift to the previous menu.
Refer to
Setup menu
