Chapter 6 : Troubleshooting
172
AP-75037, Rev. 1.1, 24/04/2006
6.4 WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
6.4.1 How to remove a piece of media (cut media)
Step 1 :
Press [F4] to raise the pressure rollers.
•
The MEDIA SET lamp will turn on (orange).
•
The following message is displayed on the operation panel.
→
Please Set Paper
Heaters
Cleaning
Cut&Feed
LeverUp
User1
xxxm
Note :
For raising or lowering the pressure rollers, you can use the foot switch instead
of the operation panel.
Step 2 :
If a piece of media or media dust is stocked in the printer, open the front cover and remove the
piece of media or media dust.
Caution :
•
Be sure not to pinch your fingers while opening and closing media cover.
1 = Front Cover
Step 3 :
If there is an error requiring a restart, power the printer OFF and ON again.
End of the procedure
