Chapter 2 : Product Overview
19
AP-75037, Rev. 1.1, 24/04/2006
2.3.3 Position and function of the heating elements
Heater element
Temperature
Function
Pre-heater (Heater A)
20 – 50°C
→
To open the pores to make the media more
receptive for eco solvent ink.
Fixer (Heater B)
20 – 70°C
→
To establish optimum fixation onto the media
(coated and uncoated).
→
Optimizes the dot gain control.
Post-Fixer (Heater C)
20 – 70°C
→
The post-fixer finalizes the fixation process and
helps to make the prints touch-dry.
Dryer (Heater D)
20 – 50°C
→
The dryer completes the drying for compatibility
with the take-up in combination with higher output
speeds.
→
Stickiness of printed banner materials is improved.
There have been a number of requests from the field, asking the heaters to be on by default for a few user
settings. This has now been implemented as follows:
1) For user 1 and user 8 default settings are as follows:
a. Pre heater A: 50°C
b. Fixer
B:
55°C
c. Post Fixer C: 50°C
d. Dryer
D:
50°C
2) For users 2
Î
7, by default the heaters are still OFF.
Note :
•
Please note some RIP software do not allow selection of the user from software
side. In some cases, however, user 8 has been automatically activated
.
