Oce Arizona T220UV, User Manual

Page: 83 / 114

Error Handling and Troubleshooting 83
T220UV Lamp Bulb Replacement
Introduction
This section describes how to change a UV lamp bulb when it burns out. These instructions are also contained in the kit that
you receive with a replacement lamp. Note that each kit contains only one lamp, so if both lamps burn out you need to order
two kits.
Kit Contents (Part #3012002526):
■
Cotton gloves (1 pair)
■
2 optical cleaning wipes
■
3mm Allen key
■
MSDS UV Lamp Safety Data Sheet
■
UV lamp bulb
■
Lamp replacement instructions
Purpose
To replace a UV lamp when it has burned out.
Before you begin
If you need to replace the lamp on the blot side, first use the control panel Operator/Maintenance menu to issue the "Access
Carriage" command before turning the power off. This moves the carriage to the blot side for easy access to the UV
illuminator on that side. This is not necessary when replacing the bulb on the carriage side.
Note:
When replacing the lamp bulb in the illuminator at the blot cloth station, be aware that with the power off you cannot
move the carriage manually. Also, there is no vacuum to hold the ink in the system. Eventually, the ink will start to drip from
the heads. Make sure that the carriage is parked directly over the blot cloth so that it will absorb any drips of ink. Also, when
you power the printer on again, make sure that you advance the blot cloth manually to a clean area of the roll if any ink has
spilled on it. This is not an issue when replacing a bulb on the carriage side since the waste tray will collect any spilled ink.
Required tools
Philips screwdriver,
Protective clear glasses.
Caution:
UV lamps may still be hot for a while after the printer power is set to Off in Step 2. Wait a few more minutes after
power is Off to let the illuminators cool down. Check the temperature before you handle the illuminators.