Oce Arizona T220UV, User Manual

Page: 34 / 114

34 T220UV User Guide
Emergency Stop
If a situation requires an immediate shutdown of all printer activity, press one of the three Emergency Stop buttons. To
recover from an emergency shutdown, resolve the problem that prompted the shutdown and then release the Emergency Stop
by twisting it slightly clockwise. Then press the ACCEPT button to restart the printer.
Note:
There are three Emergency Stops, one on the control panel and one on each end of the gantry. When you need an
immediate shutdown, it is also possible to open the one of the gantry doors to initiate an interlock shutdown.
Anytime an Emergency Stop is pressed, the lamps, the 48-volt (carriage and gantry motion) and the 24-volt (all other motors)
lines are disabled, effectively stopping all printer activity.
Note:
For safety, lamp power is always disabled when a door is open. Printing is not possible with lamps off (doors open).
The following table shows what happens when the Emergency Stop is pressed.
[15] Results of a Emergency Stop
[15] Results of a Emergency Stop
When a door is opened (interlock triggered) - UV lamps are always turned off:
[16] Doors Opened During Normal Operation
[16] Doors Opened During Normal Operation
When Then Message
When system idle Requires a reboot. "E-STOP/INTERLOCK OPEN"
"check and press ACCEPT to restart"
During Print All stop, requires a reboot "E-STOP/INTERLOCK OPEN"
"check and press ACCEPT to restart"
Any other motion All stop, requires a reboot "E-STOP/INTERLOCK OPEN"
"check and press ACCEPT to restart"
When Then Message
During boot up Intervention required. "Close All Doors"
"and press ACCEPT key"
When system idle Nothing. "DOOR IS OPEN"
Start up print gantry
movement Gantry stopped, intervention
required. "SYSTEM ERROR
[press ACCEPT to restart]"
"GANTRY MOTOR or ENCODER"
During print All stop, intervention required. "Door open while printing"
"close all doors and press ACCEPT"
End of print gantry
movement Gantry stopped, intervention
required. "SYSTEM ERROR
[press ACCEPT to restart]"
"GANTRY MOTOR or ENCODER"
Access carriage
from menus Access/Park occurs only if
doors closed. "Close All Doors"
"and press ACCEPT key"