Oce Arizona T220UV, User Manual

Page: 74 / 114

74 T220UV User Guide
Directions for use:
1.
Place the media on the table with a minimum offset of 2"(50mm).
2.
Turn on the vacuum.
3.
Mask off open vacuum zones with scrap pieces of media less than the height of the media printed on.
4.
Push the strips up against the long edges of the media, with the sharp edge protruding into the middle part of the media edge.
[23] Sharp edge of the strip against the media.
[23] Sharp edge of the strip against the media.
Note:
The strips will be held in place by the vacuum holes underneath them, but you can also apply tape to ensure that they
are not moved out of the desired position.