Oce Arizona T220UV, User Manual

Page: 50 / 114

50 T220UV User Guide
How to Use the Media Vacuum
The Media Vacuum System
Introduction
The vacuum table is a thin hollow rectangular aluminum box with aluminum box extrusions forming a perimeter frame, two
1/8" aluminum skins forming the top and bottom surfaces, and aluminum honeycomb in the interior supporting the skins.
The top surface is drilled with 1mm diameter vacuum holes with a 5mm diameter counterbore to allow air flow into the table
and create a vacuum hold-down for the media.
There are four zones on the table platen. Each zone is 32” (81cm) x 62” (158cm). The first zone is always available while
the other three must be selected by the operator.
Purpose
The vacuum table platen holds the media in place during printing, if the vacuum is activated.
When to do
When you finish selection of all print parameters, the operator control panel displays a reminder to turn on the vacuum system
before you begin the print job.
Note:
The position of the individual control handles determines whether zones 2, 3, or 4 are activated when the vacuum
system is on.
Illustration
[7] Location of Vacuum Zones
[7] Location of Vacuum Zones