Océ imagePRESS C7010VPS series, Technical Manual

Page: 267 / 362

parameter is present, an equal amount of trim is done at the top and the bottom of the book, to
centre the book on the media.
Remark
Width and Height specification cannot be mixed with oce:CutWidth and oce:CutHeight
specification (see next section).
Trimming (specify the amount of paper that must be cut)
Syntax
XPath: /JDF[contains(@Types="Trimming")]/ResourcePool/TrimmingParams/
GeneralID[@IDUsage="oce:CutHeight"]/@IDValue
Type
Double
Unit = point (1 point=1/72 inch)
Syntax
XPath: /JDF[contains(@Types="Trimming")]/ResourcePool/TrimmingParams/
GeneralID[@IDUsage="oce:CutWidth"]/@IDValue
Type
Double
Unit = point (1 point=1/72 inch)
Description
CutHeight and CutWidth specify the amount of paper that must be cut off the book after folding. If
one-way trimming is requested, the oce:CutHeight must not be used. The oce:CutHeight
parameter specifies the amount to cut both on top and on bottom. The total amount that is cut in
the height direction, is 2 x oce:CutHeight.
Remark
oce:CutWidth and oce:CutHeight specification cannot be mixed with Width and Height
specification (see previous section).
Output / finishing
Chapter 10 - JDF interface specification 267
imagePRESS C7010VPS series v2.2