Obihai OBi100, Administration Manual

Page: 176 / 220

Copyright 2010-2013 Obihai Technology, Inc. 176
$NOEC1 = Disable echo canceller once in the next call on this phone port (phone-port specific; admissible value: 1) (Not
available on OBi100/OBi110)
$NOJI1 = Disable jitter buffer adjustment once in the next call on this phone port (phone-port specific; admissible value: 1)
(Not available on OBi100/OBi110)
$IBDT = Enable in-band DTMF transmission once in the next call on this phone port (phone-port specific; admissible value:
1) (Not available on OBi100/OBi110)
$BCLR = Clear all blocked callers (trunk specific; admissible value: 1)
$CIDG = Enable Generate Caller ID Generation on this phone port (phone-port specific; admissible value: 1 for enable, 0 for
disable)
$CWCIDG = Enable CWCID Generation on this phone port (phone-port specific; admissible value: 1 for enable, 0 for disable)
$MWIG = Enable MWI (Stutter Tone) Generation on this phone port (phone-port specific; admissible value: 1 for enable, 0
for disable)
$VMWIG = Enable VMWI Generation on this phone port (phone-port specific; admissible value: 1 for enable, 0 for disable)
$BXRN = Blind transfer number for the current call on this phone port (phone-port specific; admissible value: a number
representing the blind transfer target). As soon as a complete blind transfer target number is collected, the OBi will (blind)
transfer the current call peer to the target number.
$CDM1 = Codecs to enable in the next call on this phone port (temporarily overriding any codec preferences in device
configuration) (phone-port specific; admissible value: An 8-bit unsigned number where each bit of its value represents one
audio codec:
- Bit0 (LSB) = G711u
- Bit1 = G711a
- Bit2 = G726r16
- Bit3 = G726r24
- Bit4 = G726r32
- Bit5 = G726r40
- Bit6 = G729
)
$LDN = last dialed number on this phone port (for redial) (phone-port specific; read only)
$LCR = last caller’s number on this phone port (for call return) (phone-port specific; read only)
$SPD[ n ] = number for the speed dial n ( n = 1 – 99) (global; admissible value: literal or token representing a phone number)
$CODE = the digit(s) representing the variable part of a star code (see examples below; read only)
Variable names are CASE INSENSITIVE.
Star Code Script Actions ( ACT )
The general format of an action: ACT ( par , par , ….)
The following actions are supported: