Obihai OBi100, Administration Manual

Page: 136 / 220

Copyright 2010-2013 Obihai Technology, Inc. 136
OBiBlueTooth Parameter Guide:
Parameter
Description Default Setting
Enable
Enable the OBiTALK Service (the built-in free voice
service that comes with every OBi Device)
Yes
DigitMap Digit map to restrict numbers that can be dialed or
called with this service. See
OBi Call Routing and Digit
Map Section for a description of the syntaxes for
specifying a Digit Map.
(<ob>xxxxxxxxx|obxxxxxxxxx)
InboundCallRoute Routing rule for directing incoming calls on this service.
The default rule is to send all incoming calls to the
PHONE port (ph). See
OBi Call Routing and Digit Map
Section for a description of the syntaxes for specifying
this parameter
ph
RingProfile Select a Ring Profile to ring the PHONE port with when
an incoming call is routed to the PHONE port. Choices
are A, or B A
DefaultRing Default ring pattern number to ring the PHONE port for
incoming calls on this trunk that are routed to the
PHONE port according to the InboundCallRoute of this
service. The ring pattern is taken from the selected Ring
Profile. Valid choices are 1-10 2
CallOnHoldRing Pattern to ring PHONE port when holding a call on this
trunk that has been connected to the PHONE port.
Typically this is a very short distinctive ring pattern that
serves as a reminder to the user that a call is being on
hold. The ring pattern is taken from the selected Ring
Profile. Valid choices are: NO Ring, or 1-10 8
DirectoryNumber The phone number of the connected mobile phone
service. This is just informational with no significance
OBiBLueTooth Calling Features Parameter Guide:
Parameter Description Default Setting
CallForwardUnconditionalEnable Enable call forwarding of all calls unconditionally by the
device. If CallForwardUnconditionalNumber is blank, this
parameter is treated as if it has been set to
No .
Note: It is possible for a user to set this parameter from
the phone using a Star Code
No
CallForwardUnconditionalNumber Directory number to forward all incoming calls on this
service unconditionally. Maximum Length is 127
characters.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
CallForwardOnBusyEnable Enable call forwarding of all incoming calls when the
device is busy. If CallForwardOnBusyNumber is blank,
this parameter is treated as if it has been set to
No .
Device is considered busy if one of the following
conditions holds:
This service already reaches the limit of simultaneous
calls as specified in MaxSessions
DND (Do Not Disturb) Service is enabled on this service
If the call is routed to the PHONE port where the phone
No