Obihai OBi100, Administration Manual

Page: 147 / 220

Copyright 2010-2013 Obihai Technology, Inc. 147
conference calls (SIP only). In addition, the following rule
{cbridge:SP x ( bridge-userid )}
must also added to the phone port’s OutboundCallRoute
parameter, where
x =1,2,3,4, and bridge-userid the userid
of the conference bridge SUA. Note that the keyword
cbridge is hard-coded and must not be changed.
Note: Option not available on OBi100/110
CallWaitingEnable Enable call waiting service. Call Waiting is the situation
where a new incoming call is routed to the PHONE port
when there is already another call connected. If this
service is enabled, OBi plays call-waiting tone to alert the
user, as well as generates CWCID signal if CWCID is
enabled. The user may then swap between the two calls
by hook flashing. If the service is disabled, OBi rejects the
incoming call as busy.
Note: It is possible for the user to set this parameter from
the phone using a Star Code Yes
ToneProfile Select a Tone Profile for call progress tone generation.
Choices are A, or B A
StarCodeProfile Select a Star Code Profile for interpreting Star Codes
entered by the user. Choices are None, A, or B. If value is
set to None, no star code will be recognized by OBi
device. A
LastDialedNumber Last number dialed out on the PHONE port
LastCallerNumber Last caller's number that rings the PHONE port
AcceptMediaLoopback Enable the device to accept incoming media loopback
calls Yes
MediaLoopbackAnswerDelay Delay in milliseconds before the device answers an
incoming media loopback call 0
MediaLoopbackMaxDuration Maximum duration in seconds to allow for an inbound
media loopback call. Set the value to blank or 0 to make it
unlimited 0
RepeatDialInterval Interval in seconds between retry in a repeat dial
operation. 30
RepeatDialExpires Duration of time in seconds when a repeat dial operation
remains active. 1800
GenerateCPCSignal Controls when the device should generate a CPC signal
when the remote party hangs up on an established call.
The choices are:
- Never
- For Inbound Calls Only
- For Outbound Calls Only
- For Inbound and Outbound Calls
For Inbound and Outbound
Calls
EnableLINEPortBargeIn This option is useful only when a PSTN line is connected
to the OBi110. By default a user can pick up the phone
and dial # to connect to the LINE port. If no one else using
the PSTN line at that time, the user will hear dial tone
from the phone company. On the other hand, if the line is
already in use, the user will hear fast busy tone if this
option is disabled, or join the current call in progress No