Obihai OBi100, Administration Manual

Page: 146 / 220

Copyright 2010-2013 Obihai Technology, Inc. 146
CallWaitingCallerIDEnable Enable Call Waiting Caller ID (CWCID) Signal generation.
CWCID signal is sent to the phone when it is in the off
hook state. It starts with a handshake between the OBi
device and the attached phone, by exchanging audible
short tones. OBi will proceed with the transmission of the
remaining Caller ID signal only if the handshake succeeds
(with a phone is capable of displaying CWCID). In that
case the phone mutes the handset earpiece until the
CWCID signal is complete. Some users however may still
find the audible handshake tones objectionable,
especially if their phones do not support CWCID. We
recommend to those users to set this option to No, if they
do not want CWCID feature, or do not have phones that
are capable of displaying CWCID. Yes
MWIEnable Enable MWI Signal (stutter dial tone) generation. If
enabled, any SP voice service enabled on the device that
has MWI Service enabled will trigger the generation of
stutter dial tone if there are new voicemails for the
subscriber on the service provider’s voicemail system. Yes
VMWIEnable Enable VMWI Signal generation. If enabled, any SP voice
service enabled on the device that has VMWI Service
enabled will trigger the generation of VMWI signal if
there are new voicemails for the subscriber on the service
provider’s voicemail system. Yes
CallTransferEnable Enable Call Transfer. Call Transfer, if enabled, is initiated
by the user by hanging up the phone in one of the
following scenarios:
- One call on hold while a 2
nd
outgoing call ringing
- One call on hold while a 2
nd
outgoing call connected
- One call connected while a 2
nd
outgoing call ringing
- 3-way conference with both calls connected
If Call Transfer is disabled, hanging up the phone in the
above scenarios simply ends all the calls, except for the
one that is holding, which will remain on hold (cases 1
and 2).
Yes
ConferenceCallEnable Enable 3-way Conference Call w/ local audio mixing.
Conference Call, if enabled, is initiated by the user by
hook flashing the phone in one of the following scenarios:
- One call on hold while a 2
nd
outgoing call ringing
- One call on hold while a 2
nd
outgoing call connected
We refer to case (1) as an early conference, where the
second conferencee is still ringing; the other 2 parties
may converse while hearing ringback tone in the
background until the 3 party answers. In either case, the
user can end the call with the second conferencee by
hook flashing another time and the call reverts to a 2-way
call.
If Conference Call service is disabled, then hook flashing
the phone resumes the holding call but ends the second
outgoing call in scenario (1), and swaps between the two
calls in scenario (2) (as in a call waiting situation)
Yes
UseExternalConferenceBridge Enable the use of an external conference bridge for No