NTT docomo FOMA N705i, Instruction Manual

Page: 142 / 518

140
Camera
Changing the Shooting
Settings
You can change the camera settings such as the
zoom or Auto timer.
Using the zoom
Using the zoom enables you to adjust the image
being shot to your desired size.
z
The zoom is digital.
1
Each shooting screen Use
v
to
adjust the zoom
The image is zoomed in/out by one step each
time you press
v
, and hold down it to zoom in/
out continuously.
■ Maximum zoom rate for each image size
Using the auto timer
z
The Auto timer is reset to “OFF” each time you
finish shooting.
1 Each shooting screen
u
(FUNC)
“Auto timer” “ON” Enter the time for
the Auto timer (01 to 15 seconds in 2
digits)
“10 seconds” is the default setting.
● If you set the Auto timer
“ ” appears on the screen to indicate that the Auto
timer is set.
Pressing
d
(Record) plays the Auto timer tone and
the Auto timer starts.
The Shooting indicator flashes in red and “ ” on
the screen and the backlight of
op
keys also flash.
The countdown tone sounds about 5 seconds before
the shooting. The incoming call lamp flashes rapidly.
■
To cancel the Auto timer settings
u
(FUNC) “Auto timer” “OFF”
■
To stop the timer while it is running
o
(Quit) or
t
N
z
“1×” is the default setting when you launch the
camera. Changing the image size or camera mode
also changes the zoom to “1×”.
Image size
Shoot still
image
Movie mode
Rear camera (16 steps adjustment)
2M/1M
― ―
VGA Approx. 1.8×
―
CIF Approx. 1.7×
―
Screen Approx. 1.8×
―
QVGA V. Approx. 2.4×
―
QVGA
―
Approx. 1.8×
QCIF Approx. 3.3× Approx. 3.3×
SubQCIF Approx. 4.6× Approx. 4.6×
Front camera (2 steps adjustment)
VGA
― ―
CIF Approx. 1.8×
―
Screen
― ―
QVGA V. Approx. 1.5×
―
QVGA
―
Approx. 2.0×
QCIF Approx. 2.0× Approx. 2.0×
SubQCIF Approx. 2.0× Approx. 2.0×
N
z
During the Auto timer countdown, you can shoot
manually by pressing
d
(Record).
z
The Auto timer cannot be used in M-Continuous
shooting.