NTT docomo FOMA D701I, Manual

Page: 369 / 517

366
Ot
her Co
nven
ient
Fu
nct
ion
s
5
Press
&
to switch to
Set others
screen select each items to set.
6
Press
p
.
or (when a schedule alarm is also set) is indicated in the stand-by display. When FOMA
terminal is closed, press
i
,
j
or
b
to display or (when a schedule alarm is also set) on
the sub-display.
When the set time arrives
The alarm screen appears and the alarm sounds. The screen as shown below or the set video/i-motion
appears on the display and the alarm sounds at the volume set. If lighting or vibrator is set, it operates
according to its setting.
When FOMA terminal is closed, a message
Alarm
and time appear on the sub-display.
･
If some operation such as call is going on at the set time, the terminal operates as follows:
･ During a call, the warning sound but the alarm occurs and the alarm screen appears. In addition, the
vibrator does not operate even if FOMA terminal has been set to notify a call by vibration. During
On-hold, the above operation is available after canceling On-hold.
･
When power is off, neither the power is turned on nor the alarm sounds. If you want to let the alarm
sound, set Alarm Auto Power ON to
ON
.
･ When the set time arrives during data transmission/reception (except packet communications),
during an incoming or outgoing call or while clearing a call, the alarm operates after those operation
ends.
INFORMATION
● While Silent Mode is active, the alarm does not usually sound and the vibrator set for Alarm Clock is
activated and the call indicator lights/flashes. However, the alarm setting applies when ON is set for
Vibrator and Alarm/Schedule sound of Customize Silent Mode.
● When FOMA terminal is closed, press
j
or
b
to stop the alarm. However, the alarm sound does not
stop even though you press
j
or
b
locked with the side keys.
● When multiple alarms are set for the same time, the alarm set for the smallest item number in the alarm list
is activated.
●
When alarm and schedule alarm are set for the same time, the screen that notifies alarm appears at first,
but followed by the snooze operation and then schedule alarm is notified. Even if the schedule alarm
screen is finished, the snooze operation of alarm is continued.
●
When All Lock or PIM Lock is activated, Alarm does not sound.
Vibrate alert
： Sets the vibration used at the alarm time.
Lighting pattern
：
Sets the lighting pattern of the call indicator for the alarm
time.
･
When Sync melody or OFF is set, Lighting color cannot be set.
Lighting color ： Sets the color of the call indicator shown at the alarm time.
･
Pressing
f
while the alarm is sounding stops the alarm sound and the
display before sounding reappears.
･
If the terminal is left unoperated for about 1 minute or a key other than
f
or
i
is pressed, the alarm sound stops. After that the terminal rings for 1
minute followed by a 4-minute silent period repeatedly for 30 minutes (snooze
operation). In case of setting video/i-motion, the first image is displayed.
Likewise, in case of an incoming voice call or video-phone call during the
alarm, the snooze operation is activated.