NTT docomo FOMA D701I, Manual

Page: 45 / 517

42
Bef
o
re Usin
g D7
01i
Attaching/removing the battery pack
･
Turn the power off and close FOMA terminal before attaching or removing the battery pack.
･ Be careful not to touch the camera lens.
Attaching the battery pack
a
Remove the rear cover.
While pressing the top of the rear cover with your thumb,
slide it in the direction of the arrow until it is removed.
b
With the DoCoMo logo and recyclable mark of the
battery pack facing up, insert the battery pack into
FOMA terminal in the angle as shown in the figure.
Do not force the battery pack terminals into FOMA
terminal. Doing so could damage these terminals or the
body connector.
c
Push the battery pack in.
d
Place the rear cover plate so that it can slide about
2 mm on the FOMA terminal.
e
Slide the rear cover in the direction of the arrow
pushing its center by finger so that FOMA terminal
and the rear cover do not gap.
Failure to follow the correct procedure could damage the
rear cover.
Removing the battery pack
a
Remove the rear cover.
b
Lift the edge of the battery pack with your finger and
remove it.
Battery recycling
FOMA terminal uses a lithium ion battery containing valuable materials that should be recycled. To protect the
environment, return used batteries to an NTT DoCoMo service counter, NTT DoCoMo agent or recycling center.
●
Please take the following precautions when recycling batteries:
･
Attach a piece of adhesive tape on the terminals of used battery packs
･
Do not disassemble or modify battery packs
INFORMATION
● The FOMA terminal display uses an active LCD. Due to the characteristics of the active LCD, residual
images or crossbar may remain for a while when the battery pack is attached or removed. This is not a fault
of FOMA terminal.
Press this part
Li-ion