NTT docomo FOMA D701I, Manual

Page: 43 / 517

40
Bef
o
re Usin
g D7
01i
UIM security codes
The PIN1 and PIN2 codes are used for the UIM.
Both codes are set to “0000” at time of subscription to the FOMA service. You can change this to any
code (4 to 8 digits).
☛
P138
･
The PUK (PIN Unblocking Key) is the 8-digit number used to unblock the PIN1 and PIN2 lock. It is
given to you at time of purchase.
･
If you enter the PUK incorrectly 10 times in a row, the UIM is locked. Be sure to keep a separate note
of the number. Please be notified, if you forget your PUK or cannot release the lock of UIM, you need
to bring your FOMA terminal, UIM and identification (driver’s license etc.) to a DoCoMo Shop.
Unblocking PIN lock
☛
P139
Inserting the UIM
a
Slide the locked section in the direction
of the arrow.
b
Insert the UIM into the slot in the
direction shown in the figure with the IC
side of the card facing down.
c
Push in the UIM fully until it is clamped
after the locked section is returned to its
original position.
Removing the UIM
a
Slide the locked section in the direction
of the arrow.
The UIM comes out of the slot.
b
Pull the UIM out of the slot.
INFORMATION
●
Insert or remove the UIM carefully as forcing it may damage the card.
●
Carefully handle the removed UIM so it does not become lost.
●
Note that the UIM may pop out when removing it.
●
If it is hard to remove the UIM because its pop-out amount is small, try to remove the card after reinserting
it until it stops.
PUK (PIN Unblocking Key)
UIM
Cut corner
Cut corner
IC
Locked
section
View with the UIM attached
correctly
Locked
section
Locked
section
Note: The miniSD memory card is not included in the bundle and needs to be purchased.
☛
P328