Nortel CallPilot 702t, Installation And Configuration Manual

Page: 86 / 306

Using CallPilot Manager to monitor hardware Standard 1.0
86 CallPilot
Stop versus Courtesy stop
The following two methods of taking a component out of service allow you
to choose how active calls are affected:
Courtesy stop
A Courtesy stop takes the component out of service only after the
component has finished processing the active call.
If the component is currently processing a call, the call is not dropped;
the component remains active until the call is finished.
If the component is not currently in use, it is taken out of service
immediately.
Courtesy stop is preferred over a regular Stop.
Stop
A Stop takes the component out of service immediately, regardless of
whether the component is currently processing calls. All active calls are
dropped. Typically, you perform a Stop only when severe problems that are
affecting a large number of incoming calls occur or if your organization
determines a special need for it.
Components that can be started and stopped
Only the following components can be started and stopped:
Note: If you want to start or stop more than one or two multimedia (DSP) or
call (DS30X) channels, use the Multimedia Monitor or Channel Monitor.
For instructions, see Section C: “Working with the Multimedia and Channel
Monitors” on page 97.
Component Effect of stopping
Media Bus Takes all call processing resources out of
service.