Nortel CallPilot 702t, Installation And Configuration Manual

Page: 136 / 306

Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive Standard 1.0
136 CallPilot
14 Attach power and signals cables to all drives installed in the bay. Connect
the SCSI signal cable to the wide connector on the baseboard or to the
RAID controller, as appropriate. See “SCSI and IDE cabling illustrations”
on page 126.
For proper cooling and air flow, neatly fold and secure the excess signal
cable so that the cable does not drape across the baseboard or add-in
boards. Use a tie wrap or cable clip to tie back the cable.
15 Reinstall the side cover.
16 Do one of the following steps:
a. If this is a RAID system, then hard drives must be added in pairs.
Configure the new RAID pair as described in Chapter 9, “Performing
RAID maintenance.”
b. If this is a non-RAID system, run the SCSI Select utility to configure
the new hard drive.
Hard drive location and SCSI ID configuration
RAID system
See “SCSI and IDE cabling illustrations” on page 126 for more information.
Location of drives in
internal drive bays SCSI
channel
SCSI ID
System
pack label
Top slot 0 0 A-0
Second slot from top 0 1 B-0
Third slot from top 0 3 C-0
Fourth slot from top 1 4 A-1
Fifth slot from top 1 5 B-1
Sixth slot from top
(bottom slot) 1 6 C-1