Nortel CallPilot 702t, Installation And Configuration Manual

Page: 145 / 306

October 2002 Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive
Part 5: 702t Server Maintenance and Diagnostics 145
10 Place the drive carrier on the component side of the drive to align the
four mounting holes.
11 Attach the brackets to the drive with four screws of the appropriate size
and length (reuse the screws you removed before). Tighten the screws
firmly. See “Installing the floppy disk drive” on page 146.
12 Position the drive/bracket assembly under the bottom 5.25-inch bay.
13 Slide the assembly toward the front of the system, and engage the
bracket tabs in the slots under the bottom bay.
Note: The bottom of the drive/bracket assembly must accept the tab that
sticks out from the inside of the front panel. Make sure that the front of
the drive fits flush in the front opening of the system.
14 Secure the assembly to the 5.25-inch bay with the screw you removed
earlier. Tighten the screw firmly.
15 Connect the signal and power cables to the drive.
Note: The red stripe on the signal cable must face toward the center of
the drive.
16 Reinstall the side cover.
17 Test the new floppy drive.