23
2
FRONT AXLE (DRIVE)
2210131
2210132
2mm
Shave off the standard cap
2210062
l
Fitting bolt
Disconnect brake pipes as follows.
7.
Replace pivot caps with special ones as follows.
8.
1. Drain the brake fluid from the brake oil tank.
2. Hoist the mast down and tilt it forward.
3. Disconnect the brake pipes of the wheel brake ass'y.
1. Hoist the mast down and tilt it forward.
2. Remove upper fitting bolts for both pivot caps.
3. Hoist the mast to return it to the vertical position.
4. Remove lower fitting bolts for both pivot caps.
5. Replace pivot caps with special caps.
6. Tighten all fitting bolts by hand.
7. Hoist the mast down and tilt it forward.
8. Use a tool to tighten upper fitting bolts for both special
caps.
9. Hoist the mast to return it to the vertical position.
10.Use a tool to tighten lower fitting bolts for both special
caps.
l
Disconnecting the brake pipe
l
Replacing the pivot cap
l
Special cap details
Master cylinder
Disconnect
Bushing
Pivot cap
Upper
fitting bolt
Lower fitting bolt
Disconnect
Brake pipes
CAUTION
Keep the wire rope pulling backward on the
chassis to keep the mast vertical.
CAUTION
Keep the wire rope pulling backward on the
chassis to keep the mast vertical.
Tightening torque
78-98 N m
{8-10 kgf m}
https://www.forkliftpdfmanuals.com/
