NF Wave Factory WF1947, Instruction Manual

Page: 253 / 316

WF1947/WF1948 Instruction Manual (External Control)
233
6.3.59 HLE/?HLE
Description
Selects/queries the status of the sweep poses input connector for remote.
•The sweep pose input connector is always enabled on local.
•At power-on, When the PST (:SYSTem:PRESet) or RST (*RST) command is executed,
it become HLE 1.
Parameters
Status selection (0/1)
Type 1, 2 Type 2 (For reference):
0 : OFF (disables SWEEP PAUSE IN)
1 : ON (enables SWEEP PAUSE IN)
Type 2 (For reference)
Settings: :TRIGger[:SEQueunce]:PIN:STATe {0|1|OFF|ON}
Query: :TRIGger[:SEQueunce]:PIN:STATe?
Setting example
Enables SWEEP PAUSE IN.
Type 1: HLE 1
Type 2 (For reference):TRIG:PIN:STAT ON
Compatibility Information
Although any errors do not occur, the command does not work.
6.3.60 HVU/?HVU
Description
Selects/queries the high level unit. When a unit is selected, units of low level and DC
offset are also changed.
Parameters
High level unit selection (0/1)
Type 1 Type 2 (For reference)
0
: V (V)
1 : USER (user-defined unit)
When setting with Type 2 (For reference), "DEFault" is handled as being equivalent to
"V".
Type 2 (For reference)
Settings: [:SOURce]:VOLTage[:LEVel][:IMMediate]:HIGH:UNIT
{V|USER|DEFault}
Query: [:SOURce]:VOLTage[:LEVel][:IMMediate]:HIGH:UNIT?
Setting example
Sets the high level unit to V.
Type 1: HVU 0
Type 2 (For reference):VOLT:HIGH:UNIT V
Compatibility Information
Compatibility support