NF BP4620, Instruction Manual

Page: 38 / 214

2.6 Radio Law
BP4620
2-17
2.6 Radio Law
The BP4620 complies with the High-Frequency Application Equipment provisions of Japan’s Radio
Law.
a) Related laws and regulations are summarized as follows.


Article 100 of the Radio Law defines the following equipment as “high-frequency application
equipment”.
(1) Telegraphy, telephony, or other telecommunications facilities that apply a radio frequency
current of 10 kHz or higher to a power line.
(2) Equipment specified by Ministry of Internal Affairs and Communications regulations other
than radio equipment and the equipment defined in (1) above, that uses a high-frequency
current of 10 kHz or higher.


“Ministry of Internal Affairs and Communications regulations” mentioned above refers to Article 45
of the Regulations for Enforcement of the Radio Law. Under this article, equipment that requires
authorization is defined as follows.

(1) Medical equipment (equipment used for medical treatment that generates high-frequency
energy and that uses output greater than 50 W)
(2) Industrial heating equipment (equipment used for industrial heating that generates
high-frequency energy and that uses output greater than 50 W)
(3) Various equipment (equipment that is used for heat generation or ionization and that imparts
high-frequency energy to a load)


If the usage mode corresponds to “high-frequency application equipment” as defined above,
according to Article 26 of the Radio Station License Procedure Regulations, the required application
must be submitted to the Bureau of Telecommunications that has jurisdiction over the location
where the equipment is installed, and the approval of the Minister of Internal Affairs and
Communications must be received.
For details, refer to Article 100 of the Radio Law, Article 45 of the Regulations for Enforcement of
the Radio Law, Article 26 of the Radio Station License Procedure Regulations, and Article 65 of the
Radio Equipment Law.
b) The application forms and form filling instructions can be obtained at the website of the Bureau of
Telecommunications, as well as procedure details and information about other documents to be
attached to the application forms.
c) Applications must be submitted by the person who installed the equipment. Information such as the
installation location must be filled in.
d) The BP4620’s external view drawings or photographs are required as attached documents.
If you have any questions, contact an NF Corporation.
！
CAUTION