NF BP4620, Instruction Manual

Page: 166 / 214

6.1 Error Messages
BP4620
6-5
6.1.3 Errors during operation
Table 6-3 lists error messages that are displayed when errors occur during operation.
Error messages are displayed in the message box. The message box automatically closes 1.5 seconds
later.
Table 6-3. Errors during Operation
Error Message Error Description
INVALID WITH OUTPUT ON
Setting (execution) is not possible while output is on.
INVALID WITH OUTPUT OFF
Setting (execution) is not possible while output is off.
INVALID IN THIS MODE
Setting (execution) is not possible because the mode is incorrect.
INVALID WITH THIS WAVE
Setting (execution) is not possible with this waveform.
UNDER BUSY STATE
Setting (execution) is not possible because of busy status.
UNDER REMOTE STATE
Setting (execution) is not possible because of remote status.
UNDER LOCAL STATE
Setting (execution) is not possible because of local status.
UNDER LOCAL LOCK OUT
Setting (execution) is not possible because of local lockout.
UNDER KEYLOCK
Setting (execution) is not possible because of keylock.
OUT OF LIMITER
Output cannot be switched on because of over-limiter.
OUT OF RANGE
USB parameter range check error
EXECUTION ERROR
Execution error other than above
OUT OF MEASURE RANGE
Measurement out of range
COMMAND ERROR
USB interface command error
QUERY ERROR
USB interface query error
Figure 6-2. Examples of Error Display During Operation