New Leader Raven OMNiPOWER NL5000 G5, Operator'S Manual

Page: 38 / 268

- 36 -
www.NewLeader.com
(800) 363-1771
317314-C
Raven OMNiPOWER NL5000 G5
Insert Installation
Figure 6 Figure 7 Figure 8A
Figure 6 - Once both front pads make contact, insert hardware in front mount brackets’ lower holes�
Shim between main bin and insert brackets if distance is larger than 1/8” (�32cm)� Tighten hardware per
torque recommendations in this manual�
Figure 7 - Make sure front feedgate is level. Lower endgate sealers so flush with chain shields and
tighten hardware�
Leakage of material may occur if the sealer belts are not set properly on the front of
the insert� New Leader Manufacturing is not liable for lost material due to improperly
installed sealer belts�
Figure 8A-8B - Make sure there is a complete seal
covering the gap between the insert and the main
bin’s side sheets� T ighten all hardware (1) on rubber
sealers at front of insert�
Figure 8B
Make sure rear pads are still in place against main bin� Install hardware in lower holes of rear mount
brackets� Shim between main bin and insert brackets if distance is larger than 1/8” (�32cm)� Tighten
hardware per torque recommendations in this manual�
Make sure insert’s side sheets are not resting on top of main bin’s side sheets�
Install hardware (2) in all four mount brackets’ upper holes� Tighten hardware per torque recommendations�
Remove hoist�
Inspect unit for foreign debris in conveyor area�
1
1
2