New Leader Raven OMNiPOWER NL5000 G5, Operator'S Manual

Page: 82 / 268

- 78 -
www.NewLeader.com
(800) 363-1771
317314-C
Raven OMNiPOWER NL5000 G5
Pre- and Post-Season Checklist
IMPORTANT!
Do not operate or work on machine without reading and understanding the operator’s
manual�
Before starting engine/before starting machine operation
Program rate controller and document settings Hydraulic hoses are secured properly
All stop, tail, and turn lights function properly Gearcase oil level is correct
Tire pressures are equal on each side of chassis All guards and shields in place
Battery condition and connection Spinner assy moves through full range of operation
Electrical connections are tight and secure Spinner discs and fins installed properly
All fasteners are secure Spinner discs and fins are in acceptable condition
Inverted V is secure and installed properly Material Divider assembly is square and secure
Sensor(s) are functioning properly Material Divider is clean of build-up
Lubricate all grease fittings Feedgate assembly is level and clean of build-up
Hydraulic line connections are tight Encoder installed and secured
Hydraulic gauge is functional Spinner sensor adjusted to proper gap
Chain oiler tank is full and operates correctly
Start engine/Start and run to operational temperatures
Hydraulic fittings are tight and no leaks * Conveyor control valve is operating correctly
All pressure transducers are operating correctly Calibrate radar/ground speed input
Check operation of all alarms Test maximum conveyor RPM’s
Hydraulic flow test: ____GPM @ operating engine RPM Test right and left hand spinner speed; ensure difference is
less than 5 RPM (when at operating RPM)
Check main relief valve setting :_____ PSI
Stop operation/Turn off engine and engage parking brake
Visually check for leaks All oil levels full
Check belt/chain tension and alignment
Perform Calibrations
Product density testing, crush strength, and SGN scale (See Spread Pattern Calibration section for instructions)�
Catch tests of all products and at least 1 blend for conveyor calibration and document settings and product characteristics
Spread pattern tests of all products and at least 1 blend and document settings and product characteristics
End of Season
Empty unit of all material Clean unit inside and out
Sand and touch-up paint as necessary Check for leaks
Wash chain conveyor, lube thoroughly when dry Lubricate all grease fittings
Check spinner discs and fins for wear Ensure all fasteners are secure