New Leader Raven OMNiPOWER NL5000 G5, Operator'S Manual

Page: 51 / 268

- 49 -
Raven OMNiPOWER NL5000 G5
www.NewLeader.com
(800) 363-1771
317314-C
Insert Removal/Endgate Installation
Remove insert and reinstall endgate, Inverted “V”, single conveyor Hillside Divider, etc� by following
applicable installation instructions in reverse order� Make sure the insert hydraulics, electrical connections
and air lines are disconnected from the spreader before removal� See “Inverted V” in spreader parts manual�
Hydraulics Removal
Route hydraulic hoses on the spreader and the insert as shown in Figures 18 as applicable�
LEFT HAND
BODY SIDE
TUBE CLAMP
RIGHT HAND
BODY SIDE
TUBE CLAMP
BIN 2 FEEDGATE
BIN 1 FEEDGATE
BIN 2
CONVEYOR
CONNECT TO
BIN 1 FEEDGATE
AFTER REINSTALLING
ENDGATE
Port 1
Port 2
To Port 1
To Port 2
Figure 18 - Detach M
ulT
A
pplier
Insert Removal
DO NOT check leaks with hands while system is operating as high pressure oil leaks can
be dangerous! If skin is pierced with hydraulic fluid at high pressure seek immediate
medical attention as fluid injected into the skin could cause gangrene if left untreated.
Relieve pressure before disconnecting hydraulic lines or working system� Make sure all
hydraulic fluid connections are tight and all hydraulic hoses and lines are in good condition
before applying pressure to the system� Wear protective gloves and safety glasses or
goggles when working with hydraulic systems� Failure to comply with this requirement
could result in death or serious injury�