New Leader Raven OMNiPOWER NL5000 G5, Operator'S Manual

Page: 29 / 268

- 27 -
Raven OMNiPOWER NL5000 G5
www.NewLeader.com
(800) 363-1771
317314-C
Header
Installation
Spreader Hydraulic Requirements
Hydraulics Maximum Flow
GPM (LPM)
Maximum
Pressure
PSI
Spinners & Conveyor 30 (114) 3100
MultApplier 9 (34) 2000
Recommended sequence of installation is:
1� Positioning of spreader�
2� Installation of chassis hydraulic hose and electrical wiring to spreader�
3� Installation of optional parts�
4� Lubrication�
5� Checking for leaks and proper functioning�
Lifting the Spreader
Use only lifting devices that meet or exceed OSHA standard 1910.184 or ASME B30.20-
2006� Never lift equipment over people� Never lift unit with anything or anybody in
the body� Loads may shift or fall if improperly supported� Failure to comply with this
requirement could result in death or serious injury�
Shock loading is prohibited and sudden accelerations should be avoided� Lifting in such
a manner could result in damage to unit� Failure to comply with the above warning may
result in minor or moderate injury�
Always inspect unit lift points for signs of wear, cracking, corrosion, gouges, alterations, or distortion�
Always use a sling, spreader bar, or lifting bar that
attaches to the lifting points with a minimum of
60 degrees from horizontal� It is preferable to use
an “H” style lifting bar that keeps the attaching
chains in a near vertical orientation as shown in
Figure 1� Operators of lifting devices must be
qualified and knowledgeable in their use and
application�
Work in an environment that permits clear
communication to others nearby� Keep area
clear of persons when loads are to be lifted and
suspended� Do not allow the lifted load to come
in contact with any obstruction�
Raise unit high enough to lower Support Legs
(2)� Pull Pin (1); pull support legs out and lower
into place� Place pin into locking hole to secure
support leg�
Store units on a solid surface with support legs in
the down position�
Figure 1 - Lifting Bar
1
2
1
2