Neuralog NeuraJet17, User Manual

Page: 71 / 100

NeuraJet17 User Guide
© 2014…
Neuralog
61
•
Menu
►►►►►
Adjust Printer
▼
•
►►►►►
Adjust Length
▼
•
►
Yes
o
OK to enter
A test pattern is printed for adjustment based on the amount of paper stretching or
shrinkage. The scale bar shows “Millimeter” in 50 mm units and “Inch” in 1 inch units.
The actual printed length should be exactly 20 inches.
Print Length Test Pattern .
Measure the length of the adjustment pattern. Calculate
the difference between the measured length and actual
length.
•
After the print completes a prompt will appear. At the prompt, enter the
measured difference as a percentage.
o
Adjust the value in 0.02 Increments. Press
◄
to increase the value and
►
to decrease it.
o
Press the OK button.
•
Repeat these steps to obtain another test print to measure the printer’s accuracy.
If the scale is printed shorter than actual size, set the value toward the positive side; if it
is printed longer, set the value toward the negative side.
The setting for the amount of paper stretching or shrinkage is relative. If you access it
again later, it will be displayed as 0.00%.
The measured test print should be within 99.8% of true scale once the printer length
accuracy is possible. If this cannot be achieved, contact Neuralog support.
5.9 Cleaning the Printer and CFA
You may want to periodically clean your printer to remove paper dust. To clean the
printer and CFA we recommend using a dry cloth to gently wipe the outside of the
device. You should turn the printer OFF, but there is no need to remove printer
components. Compressed or “canned” air can also be used to remove paper dust from
the blade area.