Neuralog NeuraJet17, User Manual

Page: 19 / 100

NeuraJet17 User Guide
© 2014…
Neuralog
9
2.1.3 Initial NeuraJet17 Setup
Place the printer on a table or stand and unpack all packing materials.
•
Remove all cushioning materials and tape from the printer and accessories.
•
Open the top cover, carefully raise the carriage shaft belt stopper and then pull it
forward to remove. [1]
→
[2] The carriage shaft belt stopper is a bright orange
plastic piece labeled with a red ribbon.
•
When you open the Top Cover, you will also find a Cleaning Brush [3] on the
right side.
•
Remove all other packaging materials from the printer.
Note: You will need the Belt Stopper if you move the printer to another location. Do not
discard the Belt Stopper you have removed.
Attach the Power Cord
•
Plug the power cord into the Power Socket on the back of the printer.
•
Connect the power cord directly to an outlet. Do not use a power strip.
Power on the Printer
•
Press the Power button to power on the printer.
•
After all lamps are lit and then go off, the printer starts up.