Chapter 3. Configuring Switching Information
|
175
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To configure IGMP Snooping interface settings:
1.
Interface: Lists all physical, VLAN, and LAG interfaces. Select the interface you want to
configure.
2.
Use
Admin Mode
to select the interface mode for the selected interface for IGMP Snooping
for the switch from the pull-down menu. The default is disable.
3.
Use
Group Membership Interval
to specify the amount of time you want the switch to wait
for a report for a particular group on a particular interface before it deletes that interface from
the group. Enter a value between 1 and 3600 seconds. The default is 260 seconds.
4.
Use
Max Response Time
to specify the amount of time you want the switch to wait after
sending a query on an interface because it did not receive a report for a particular group on
that interface. Enter a value greater or equal to 1 and less than the Group Membership
Interval in seconds. The default is 10 seconds. The configured value must be less than the
Group Membership Interval.
5.
Use
Present Expiration Time
to specify the amount of time you want the switch to wait to
receive a query on an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A
value of zero indicates an infinite time-out, i.e. no expiration.
6.
Use
Fast Leave Admin
mode to select the Fast Leave mode for the a particular interface
from the pull-down menu. The default is disable.
7.
Click
Cancel
to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
8.
If you make any configuration changes, click
Apply
to apply the new settings to the switch.
Configuration changes take effect immediately.
