Chapter 7. Monitoring the System
|
573
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To configure Port Mirroring:
1.
Select the check box next to a port to configure it as a source port.
•
Mode
- Specifies the Mode for mirroring. By default Mode is disabled.
2.
Use
Source Port
to specify the configured port(s) as mirrored port(s). Traffic of the
configured port(s) is sent to the probe port.
3.
In the
Destination Port
field, specify the port to which port traffic is be copied. Use the
unit/slot/port format to specify the port. You can configure only one destination port on the
system. Acts as a probe port and will receive all the traffic from configured mirrored port(s).
Default value is blank.
4.
From the
Session Mode
menu, select the mode for port mirroring on the selected port:
•
Enable
- Multiple Port Mirroring is active on the selected port.
•
Disable
- Port mirroring is not active on the selected port, but the mirroring
information is retained.
5.
Direction
- Specifies the direction of the Traffic to be mirrored from the configured mirrored
port(s). Default value is Tx and Rx.
6.
Click
Apply
to apply the settings to the system. If the port is configured as a source port, the
Mirroring Port
field value is Mirrored.
7.
To delete a mirrored port, select the check box next to the mirrored port, and then click
Delete
.
8.
Click
Cancel
to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Table
7-118.
Field
Description
Mirroring Port
Indicates the port to be in a mirrored state.
sFlow
From the sFlow link under the Monitoring tab, you can access the following pages:
• Basic
on page
573
• Advanced
on page
575
Basic
From the Basic link, you can access the following pages:
• sFlow Agent
on page
573
sFlow Agent
To display the sFlow Agent page, click
Monitoring
sFlow
Basic
sFlow Agent
.
