Chapter 4. Routing
|
295
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Route Redistribution
This screen can be used to configure the OSPF Route Redistribution parameters. The
allowable values for each fields are displayed next to the field. If any invalid values are
entered, an alert message will be displayed with the list of all the valid values.
To display the Route Redistribution page, click
Routing
OSPF
Advanced
Route
Redistribution
.
1.
Use
Source
to list available source routes that have not previously been configured for
redistribution by OSPF. The valid values are 'Static', 'Connected', and 'RIP'.
2.
Use
Redistribute Option
to enable or disable the redistribution for the selected source
protocol.
3.
Use
Metric
to set the metric value to be used as the metric of redistributed routes. This field
displays the metric if the source was pre-configured and can be modified. The valid values
are 0 to 16777214.
4.
Use
Metric Type
to set the OSPF metric type of redistributed routes.
5.
Use
Tag
to set the tag field in routes redistributed. This field displays the tag if the source
was pre-configured, otherwise 0 and can be modified. The valid values are 0 to
4294967295.
6.
Use
Subnets
to set whether the subnetted routes should be redistributed.
7.
Use
Distribute List
to set the Access List that filters the routes to be redistributed by the
destination protocol. Only permitted routes are redistributed. If this command refers to a
non-existent access list, all routes are permitted. The valid values for Access List IDs are 1
to 199.
When used for route filtering, the only fields in an access list that get used are:
•
Source IP Address and netmask
•
Destination IP Address and netmask
•
Action (permit or deny)
All other fields (source and destination port, precedence, tos, and so on) are ignored.
