window that is displayed:
i. For connection type, select
VMkernel Network Adapter
, and select
Next
.
ii. For target device, select the option to use an existing standard switch, browse to vSwitch2, and
select
Next
.
iii. Under port properties, change the network label to iSCSI-A, and select
Next
.
iv. Under IPv4 settings, provide the IPv4 information, and select
Next
.
The IP address you enter here is the iSCSI-A IP address that you copied earlier.
v. If you are ready to proceed, select
Finish
.
m. In the graphic that is displayed, select
iSCSI-A
, and select the pencil icon to edit the settings as
follows:
i. Select
Security
, and make the following selections:
ii. Select
Teaming and failover
, and select the
Override
checkbox.
iii. Move vmnic5 to Unused adapters by using the arrow icon.
iv. Select
OK
.
n. With the newly added node selected and the Manage tab open, select
Storage > Storage Adapters
,
and perform the following steps:
i. Select
+
and select
Software iSCSI Adapter
.
ii. To add the iSCSI adapter, select
OK
in the dialog box.
iii. Under Storage Adapters, select the iSCSI adapter, and from the Properties tab, copy the iSCSI
Name.
You need the iSCSI Name when you create the initiator.
Summary of Contents for HCI
Page 95: ...NetApp HCI Resources page...
Page 308: ......
