Using Your NEC Versa 6000 4-7
Removing a Device from the VersaBay II
Use the following steps to remove the standard diskette drive (or other de-
vice) from the VersaBay II, and replace it with the 6x CD-ROM reader that
ships with the system.
NOTE
A CD-ROM reader installed in the VersaBay II must be speci-
fied as a slave device in the Setup utility. Also, check that the switch
on the back of the reader is set to the right (positioned next to the S
for Slave).
If you install a hard disk drive from a Versa model E, V, M, or P in
the VersaBay II, it becomes the master drive from which the system
boots.
1.
Make sure the NEC Versa 6000 is powered off, all options are discon-
nected, and the LCD panel is closed.
2.
Turn the system upside down with the front facing you.
3.
Locate the VersaBay II release latches on the bottom of the unit.
VersaBay II release latches
Summary of Contents for VERSA 6000 Series
Page 9: ...viii Contents ...
