4-40 Using Your NEC Versa 6000
■
high-quality speakers.
See the NEC Versa Docking Station 6000 User's Guide for instructions on
connecting and using the docking station.
NOTE
Whenever you dock the NEC Versa 6000, the back IR port is
automatically disabled and the front IR port is enabled.
SETTING SWITCHES
A four-position dip switch is located next to the hard disk drive connector in
the hard disk drive bay. The following lists each switch setting and its spe-
cial function.
NOTE
Switch settings 3 and 4 are reserved for NEC factory use
only.
■
Switch 1, BIOS Flash Protection Switch — The default setting is “ON.”
Change the setting to “OFF” when you update your system’s basic in-
put/output system (or BIOS) flash memory. See “Updating the BIOS”
next, to complete this procedure.
■
Switch 2, Password Override Switch — The default setting is “OFF.”
For example, if you forget your password and cannot access the data on
your NEC Versa, change the setting to “ON” and your current password
dissolves.
To enter a new password, reset the switch to “OFF,” and follow the in-
structions in Chapter 3, “Using Setup and PowerPanel,” to set up a new
password. You may want to keep this password in a special place so that
you don’t forget it again!
■
Switch 3 — Reserved for factory use.
■
Switch 4 — Reserved for factory use.
Summary of Contents for VERSA 6000 Series
Page 9: ...viii Contents ...
