NEC HV8600, User Manual

Page: 170 / 204

C-8 Management Application Workstation
Main Menu
MWA Main menu has the following menus.
ƒ
File

New SG…registers server system generation (SG) information. This
command requires the SG information floppy disk described in
Registering SG Information on MWA. When this command is
selected, the Create a new server dialog box displays. Insert the
floppy disk and click the OK button. If the IP address in a new server
SG information exists in an old server SG information, the old
information is updated. Once the registration has been completed, the
server SG information is saved as (IP address).rp file. MWA can be
connected only to servers registered using the New SG command.

Open…opens a server window for a specified server. The Open a
Server dialog box lists SG-registered servers on MWA. Select a
server to operate.

Close…closes the active server window and disconnects the server.

Delete…deletes the SG information for the selected server.

Write back SG…saves server SG information on a floppy disk. The
SG information can be set again using the floppy disk. When this
command is selected, the Write back a server dialog box displays.
Insert a formatted floppy disk and select the OK button. Then, select
a server from the server list. SG information for only one server can
be saved on a floppy disk because the server SG information for all
files are saved under the same name.

Properties…displays or set properties for the current server. If no
servers are in operation, the Select a Server dialog box opens. Select
a server to change its properties. In the Server Properties dialog box,
view or set necessary information.

Defaults…allows you to view and set basic properties for all servers
in the Default Server Properties dialog box. If [Use Default Settings]
is checked in the Server Properties dialog box, server properties are
set to the values specified in the Default Server Properties dialog
box.

Configure…changes MWA configuration in the Configure dialog
box. Timer counts for no response detected. After connecting to a
server, MWA sometimes cannot receive any response from the
server because the server is busy. If the server responds within
specified timer count, MWA does not close communication. Increase
the timer count if you expect the server to be busy for a long time.
The default is 300 seconds.