NEC HV8600, User Manual

Page: 134 / 204

5-14 Problem Solving
Table 5-1. POST Error Codes and Messages (continued)
Error Code and Message Explanation
Action
0B71 System Temperature out of
the range Abnormal temperature was
detected. Turn off the power once.
Then check whether the fan
is clogged. Clean it if the fan
is covered with dust. If no
error is found or the failure is
cleared in spite of cleaning,
contact your service
representative.
0B74 The error occurred during
voltage sensor reading An error occurred during detection
of voltage. Contact your service
representative.
0B75 System Voltage out of range Abnormal system voltage was
detected. Contact your service
representative.
0B78 The error occurred during fan
sensor reading An error was detected during read
of FAN sensor. Contact your service
representative.
0B7C The error occurred during the
redundant power module
confirmation An error occurred while redundant
power supply was configured. Contact your service
representative.
0B80 IBF or OBF Check Error
occurred by the access via
System Management
Controller No response was issued for
access to System Management
Controller. Contact your service
representative.
0B81 System Management
Controller Firmware CRC
check error occurred An error occurred in firmware of
System Management Controller. Contact your service
representative.
0B82 Hardware error of System
Management Controller
occurred A hardware error was detected in
System Management Controller. Contact your service
representative.
0B83 All Device of 1
st
System
Management Bus became not
able to accessed
SMBus could not be accessed via
System Management Controller. Contact your service
representative.
0B84 Some Device of 1
st
System
Management Bus became not
able to accessed
No device could be accessed
through SMBus access via
System Management Controller. Contact your service
representative.
0BA0 Address Array on CPU box
#1 error Contact your service
representative.
0BA1 Address Array on CPU box
#2 error Contact your service
representative.
0BA2 Data Array on CPU box #1
error Contact your service
representative.
0BA3 Data Array on CPU box #2
error Contact your service
representative.
0BAB PCI Bus #3 connection
hardware error occurred Contact your service
representative.
0BB0 SMBIOS – SROM data read
error Reading SROM data failed. Contact your service
representative.
0BB1 SMBIOS – SROM data
checksum bad SROM data checksum was
incorrect. Contact your service
representative.