NEC HV8600, User Manual

Page: 112 / 204

4-40 Upgrading Your System
A
B
Figure 4-33. Engaging the Device Side Rails to the Bay Guide Rails
11.
Connect a power cable to the back of the drive (see Figure 4-34).
Note:
For 5 1/4-inch devices, power cables are
provided in the chassis for removable 5 1/4-inch media
drives (including the CD-ROM that is factory-installed).
These power cables are interchangeable for 5 1/4-inch
devices only; you can connect any one of them to any
device you install in the 5 1/4-inch media bays. The
connectors are keyed and can be inserted in only one way.
For 3 1/2-inch diskette drives power cables are provided in
the chassis (including the diskette drive that is factory-
installed). The connectors are keyed and can be inserted in
only one way.
12.
Connect the data cable (see Figure 4-34) to the device; the connector is
keyed and can be inserted only one way.
Note:
For the 5 1/4-inch devices, be certain that you are
using the 50-pin SCSI data cable. This cable comes from the
system I/O board to the removable media bays and ends at
the CD-ROM drive in bay D. Do not confuse this cable with
the 34-pin diskette drive cable which begins on the system
I/O board and ends at the diskette drive in bay F.
13.
Reinstall the top panel, left front door, and the left side panel. Power on the
system.